topic Re: sheet metal problem in Fusion Design, Validate & Document Forum

sheet metal problem

furkan.zaman — Mon, 27 Dec 2021 15:35:20 GMT

There are two panels. These panels meet each other in a corner. This corner needs to be bent

If I delete one of the panels and try to do it from the other panel, the result is like this

Since the large panel is curved, it does not allow drawing and tilting. I can't select the line in the drawing

Re: sheet metal problem

TheCADWhisperer — Mon, 27 Dec 2021 18:12:46 GMT

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

Are all of your sketches fully defined?

Are there any unresolved issues highlighted in your Timeline?

Re: sheet metal problem

furkan.zaman — Wed, 29 Dec 2021 14:39:47 GMT

The two panels make corners with each other. These panels are drawn separately. then want to be joined with a twist.

Re: sheet metal problem

TheCADWhisperer — Wed, 29 Dec 2021 15:13:24 GMT

Are all of your sketches fully defined?

Are there any unresolved issues highlighted in your Timeline?

Shouldn't these be Components?

See Attached....

Re: sheet metal problem

furkan.zaman — Wed, 29 Dec 2021 17:50:34 GMT

Thank you for your solution. A solution like this is really compelling. It is possible to do this with a single command in catia v5. I thought there might be an easy solution in fusion 360 as well. As far as I understand now, there is no short solution.