topic Re: Cannot use Emboss in Fusion Design, Validate & Document Forum

Cannot use Emboss

eric.thepaut3 — Wed, 19 Jan 2022 22:31:53 GMT

Hello,

i would like to use emboss, but the surface on which i want to emboss my sketch is the only one i can't select. I don't understand. I want to project the bat on the guitare top curved face....

Thanks

Here is my build : https://a360.co/3sSqfh3

Re: Cannot use Emboss

jeff_strater — Wed, 19 Jan 2022 22:55:33 GMT

Emboss today only works on relatively simple surfaces (cylinder, etc). However, we are working on a more complex version of emboss that will handle doubly-curved surfaces.

Re: Cannot use Emboss

eric.thepaut3 — Wed, 19 Jan 2022 23:09:30 GMT

Ok, thank you for your quick answer. But so bad actually...

What could i use to mimic emboss? Project?

Re: Cannot use Emboss

jhackney1972 — Thu, 20 Jan 2022 01:25:29 GMT

You said you wanted to Emboss, which is raised. Your model as downloaded was Deboss, which is cut into the surface. I did an Emboss, it can be reversed and you can close in the center or made multiple heights. You tell me.

Re: Cannot use Emboss

eric.thepaut3 — Thu, 20 Jan 2022 09:35:13 GMT

When i load your file, i have this message... Do you know what it means?

Re: Cannot use Emboss

g-andresen — Thu, 20 Jan 2022 10:37:23 GMT

Hi,

The file is created with a newer version of Fusion.
If your system is updated to this version it should work.

günther

Re: Cannot use Emboss

eric.thepaut3 — Tue, 25 Jan 2022 10:55:17 GMT

Thank you guy. I finally did it!!!