topic Re: Shelling Issue on an Angle in Fusion Design, Validate & Document Forum

Shelling Issue on an Angle

jrobersonJE6HW — Thu, 20 Jan 2022 23:39:58 GMT

I've been trying to shell a piece but when it shell it doesn't cut the angle but makes a straight edge. Is there a work around or something to fix this issue?

Re: Shelling Issue on an Angle

jeff_strater — Fri, 21 Jan 2022 00:22:54 GMT

can you share the model here? Cannot tell from just an image. Thanks.

Betreff: Shelling Issue on an Angle

mango.freund — Fri, 21 Jan 2022 04:48:44 GMT

why do you have interruptions here? are these bodies that are not connected? that could cause the problem. greetings mango

Betreff: Shelling Issue on an Angle

jrobersonJE6HW — Fri, 21 Jan 2022 07:11:29 GMT

Those aren't interuptions. Thats just the sketch being visible, as I wanted to show how I would've liked the shell to cut the piece. Which, as you can see on picture where I circled the angle being cut off and straightening instead of shelling continious angle.

Re: Shelling Issue on an Angle

jrobersonJE6HW — Fri, 21 Jan 2022 07:18:49 GMT

Here are some pictures

Re: Shelling Issue on an Angle

TrippyLighting — Fri, 21 Jan 2022 08:47:04 GMT

We need the model in .f3d format, not images of the model.

Re: Shelling Issue on an Angle

jrobersonJE6HW — Fri, 21 Jan 2022 09:10:50 GMT

AH! Okay. Here you go.

Re: Shelling Issue on an Angle

WHolzwarth — Fri, 21 Jan 2022 10:48:07 GMT

There's a small vertical face between the red face and the internal bottom.

Delete it before the last shell, and it's ok. See section below.