topic Betreff: How to recalculate a model in Fusion Design, Validate & Document Forum

How to recalculate a model

gillesht — Fri, 11 Feb 2022 19:48:41 GMT

Hi,

I made a change to my skecth, how do I get the model to be recalculated?

Best regards.

Betreff: How to recalculate a model

mango.freund — Fri, 11 Feb 2022 19:53:49 GMT

if you have your history "timeline" turned on, move the cursor to the beginning and start like a movie. watch out for all yellow sketches and red warnings. BR mango

Re: How to recalculate a model

jhackney1972 — Fri, 11 Feb 2022 20:09:26 GMT

Normally the update will happen automatically after you leave the sketch. You can force an update by selecting this indicated command.

Betreff: How to recalculate a model

gillesht — Fri, 11 Feb 2022 20:22:41 GMT

Hi,
I ran construction timeline but Im trying to measure the new diameter of the base of the lamp shade without success. So I’m not sure of the result. The diameter should be 133 mm. I’m sending you my model. If you could confirm that the recalculate was done, it would be greatly appréciâted.
Best regards.

Betreff: How to recalculate a model

jhackney1972 — Fri, 11 Feb 2022 20:28:06 GMT

If you attached your model to your Forum post, it did not make it. You cannot attach files using email, they must be attached using the Forum Attachment section.

Betreff: How to recalculate a model

gillesht — Fri, 11 Feb 2022 20:56:55 GMT

Hi,

Attach is the model.

Best regards.

Betreff: How to recalculate a model

jhackney1972 — Fri, 11 Feb 2022 21:13:25 GMT

Yes, your model has been updated. It is hard to measure the cone large diameter due to the applied fillet. Simply suppress it and then measure.

By the way, I question all the moves in your model. You need to model around the origin and join components together using Joints.

Edit: I cleaned up your model, it is attached.

Betreff: How to recalculate a model

gillesht — Fri, 11 Feb 2022 21:45:41 GMT

Hi,
I measure the large diameter and I get 130 mm. I’ve modified the sketch to have 133 mm. I don’t understand how the model was updated.
Best regards.

Betreff: How to recalculate a model

jhackney1972 — Fri, 11 Feb 2022 21:50:37 GMT

You obviously have not watched my supplied Screencast. In the Screencast I suppress the edge fillet and show that your large OD is 133mm. The Fillet rounds the edge and makes the OD smaller.

Betreff: How to recalculate a model

gillesht — Fri, 11 Feb 2022 21:58:20 GMT

Hi,

My mystake. I didn't go back to the forum to view your entire reply. In my next model I'll avoid all the moves and stick to the origin. I'm a beginner with Fusion 360.

Many thanks and best regards.