https://forums.autodesk.com/t5/fusion-design-validate-document/any-way-to-scale-extent-of-model-in-step-file-while-preserving/m-p/11080478#M60565 <P>One way would be to use the split body command to separate the inner hub from the outer then scale the outer hub and tire.</P> Mon, 04 Apr 2022 05:08:00 GMT etfrench 2022-04-04T05:08:00Z https://forums.autodesk.com/t5/fusion-design-validate-document/any-way-to-scale-extent-of-model-in-step-file-while-preserving/m-p/11080432#M60564 <P>I downloaded the attached tire &amp; wheel model in a STEP file. Is there any clever (or not so clever) way to scale the wheel portion, while preserving the sizes of the holes in the center of the wheel rim (it's OK to scale up the cut-out geometries in the outside of the wheel rim, but I'd like to keep the 5 holes in the middle as they are, if possible).</P> Mon, 04 Apr 2022 04:38:16 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/any-way-to-scale-extent-of-model-in-step-file-while-preserving/m-p/11080432#M60564 rossjm5075 2022-04-04T04:38:16Z https://forums.autodesk.com/t5/fusion-design-validate-document/any-way-to-scale-extent-of-model-in-step-file-while-preserving/m-p/11080478#M60565 <P>One way would be to use the split body command to separate the inner hub from the outer then scale the outer hub and tire.</P> Mon, 04 Apr 2022 05:08:00 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/any-way-to-scale-extent-of-model-in-step-file-while-preserving/m-p/11080478#M60565 etfrench 2022-04-04T05:08:00Z