topic Re: Fully constraining a sketch ( which consists ellipse and spline) in Fusion Design, Validate & Document Forum

Fully constraining a sketch ( which consists ellipse and spline)

tushar.kunder — Wed, 10 Aug 2022 10:20:59 GMT

how to constrain this ellipse and spline in the right?

Re: Fully constraining a sketch ( which consists ellipse and spline)

aliobidi — Wed, 10 Aug 2022 11:02:44 GMT

Hi ,

check and try this point ( it should be black ) (defined)

Re: Fully constraining a sketch ( which consists ellipse and spline)

tushar.kunder — Wed, 10 Aug 2022 11:14:24 GMT

I defined( constrained) that point. but sketch is still the same(not fully defined).

Re: Fully constraining a sketch ( which consists ellipse and spline)

g-andresen — Wed, 10 Aug 2022 11:23:35 GMT

Hi,

1. white points signal that they are not determined.
2. with the fit point spline, in addition to the coordinates of the points, the tangents must also be defined in angle and length.

günther

Re: Fully constraining a sketch ( which consists ellipse and spline)

aliobidi — Wed, 10 Aug 2022 11:37:36 GMT

attach your file

Re: Fully constraining a sketch ( which consists ellipse and spline)

TheCADWhisperer — Wed, 10 Aug 2022 11:59:42 GMT

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

What/where is the major and minor axis of your Ellipse?

I started to lay out your sketch and realized there is missing information in image alone.

Re: Fully constraining a sketch ( which consists ellipse and spline)

tushar.kunder — Thu, 11 Aug 2022 00:24:42 GMT

f3d file

Re: Fully constraining a sketch ( which consists ellipse and spline)

etfrench — Thu, 11 Aug 2022 06:07:25 GMT

Fix/Unfix the partial ellipse or don't trim the original ellipse.

Re: Fully constraining a sketch ( which consists ellipse and spline)

TheCADWhisperer — Thu, 11 Aug 2022 15:59:54 GMT

@tushar.kunder

See Attached file...