https://forums.autodesk.com/t5/fusion-design-validate-document/how-to-give-a-load-condition-in-this-case-generative-design/m-p/11396762#M53206 <P><a href="https://forums.autodesk.com/t5/user/viewprofilepage/user-id/6965551">@seth.madore</a>&nbsp;This should probably be moved to Design</P> Fri, 02 Sep 2022 04:07:55 GMT hyperbolicindustries 2022-09-02T04:07:55Z https://forums.autodesk.com/t5/fusion-design-validate-document/how-to-give-a-load-condition-in-this-case-generative-design/m-p/11396707#M53205 <P><SPAN>I'm going to make a helmet using the general design. I want all the points on the helmet to withstand the shock of up to 5,000 N, but I don't know how to give the load conditions in this case.</SPAN></P><P><SPAN>If a load of 5,000N is given to the entire surface, 5,000N will be applied as a pressure divided by the area of the surface, and if the pressure of 5,000Mpa is given, it would be too much of a design.</SPAN></P> Fri, 02 Sep 2022 03:14:42 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/how-to-give-a-load-condition-in-this-case-generative-design/m-p/11396707#M53205 16100060HK73D 2022-09-02T03:14:42Z https://forums.autodesk.com/t5/fusion-design-validate-document/how-to-give-a-load-condition-in-this-case-generative-design/m-p/11396762#M53206 <P><a href="https://forums.autodesk.com/t5/user/viewprofilepage/user-id/6965551">@seth.madore</a>&nbsp;This should probably be moved to Design</P> Fri, 02 Sep 2022 04:07:55 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/how-to-give-a-load-condition-in-this-case-generative-design/m-p/11396762#M53206 hyperbolicindustries 2022-09-02T04:07:55Z