topic Betreff: Project a hole from an imported component onto a component in Fusion Design, Validate & Document Forum

Project a hole from an imported component onto a component

rpsalas — Mon, 17 Feb 2025 16:57:45 GMT

I am using an imported step file that has a complicated assembly (without sketches). This assembly has four holes.

I want to place that assembly on top of a body in my design.

And then I want to "project"? the holes from the assembly onto the body so that, if I move the assembly the holes will move too.

I think it must be a common requirement but I have not managed to do it yet, Thanks!

Re: Project a hole from an imported component onto a component

TrippyLighting — Mon, 17 Feb 2025 17:22:00 GMT

What is your experience level with Fusion?

In the screen recording I show what I would do. For each new discrete part you'd create a component and then, with the component , start sketching and modeling that component.

To position and orient components you should use assembly joints.

(view in My Videos)

Betreff: Project a hole from an imported component onto a component

g-andresen — Mon, 17 Feb 2025 17:23:09 GMT

Hi,

try this

(view in My Videos)

günther

Re: Project a hole from an imported component onto a component

rpsalas — Tue, 18 Feb 2025 01:41:13 GMT

Thank you both! That was super helpful. My level of experience (to answer your question) is about 1 month of pretty serious learning and experimentation. I am sure I am doing lots of things wrong! Folks in this community has been super helpful!