topic Re: Variable Fillet Edge in Fusion Design, Validate & Document Forum

Variable Fillet Edge

boyleiste — Wed, 21 Sep 2022 16:35:59 GMT

Hi everyone!

I'm trying to make the edge of knife handle project exactly as on the photo but I couldn't handle it. Fillet or chamfer doesn't work since the edges have too sharp curves. If you have any suggestions I would be very appreciated.

Re: Variable Fillet Edge

TrippyLighting — Wed, 21 Sep 2022 17:20:22 GMT

The area you have highlighted is NOT a fillet. It is created by one, or more lofts between two profiles.

It would probably have been better if you continued to post it in your other thread.

Attached is a model with what believe you are looking for. before continuing to model I would remove the small decorative fillets at the end of the timeline and then add any other necessary details.

Also, it was not my goal to create a final model, but rather to demonstrate techniques that can get you there.

Re: Variable Fillet Edge

boyleiste — Wed, 21 Sep 2022 17:47:55 GMT

Dear Peter,

I have opened a new thread because of the misundertanding on the other one but thank you for your caution. I also learn forum's rules and manners.

The solution was beyond helpful. Thank you very much!

Best regards,

Sabah Petek