topic Re: Parametric modeling in Fusion Design, Validate & Document Forum

Parametric modeling

potlsnekkeri — Sat, 12 Nov 2022 09:41:45 GMT

Hello

i have tried to use parametric designe in her but when i change the heigth of the cabinet the door dont change.

is there a way to fix this ,it yes can someone show me

thanks:-)

davebYYPCU — Sat, 12 Nov 2022 09:56:41 GMT

Sure, connect white point here to purple point.

Skap:1 Sketch 1.

Fully defined sketches work really good with Parameters, blue lines and white points are not fully defined.

Bunga777 — Sat, 12 Nov 2022 10:28:12 GMT

Fix it.

I added it because a few restraints were missing in a few sketches.

Both are bound by Collinear and Coincident.

Since totalhøyde is assigned to konvolut.sketch1, other sketches will follow if they are constrained to match the totalhøyde sketch.

skap.Sketch1

bakplate sketch1

Note that while the lines in the sketch are blue, their positions are not fixed.

It would be a good idea to add dimensions and constraints so that all the lines in the sketch are black and fixed in their original positions.

I took a video. Please refer to it.

potlsnekkeri — Sat, 12 Nov 2022 14:19:36 GMT

Thanks alot

how is the best way to use parametric designe and make 4 cabinets so that can fit into a length of 3340mm ?

g-andresen — Sat, 12 Nov 2022 15:29:15 GMT

Hi,

just take a look at this thread (#6)

günther

davebYYPCU — Sat, 12 Nov 2022 17:11:42 GMT

Make one, 3340/4 long,

Rectangular pattern 3340/4 spacing.

count 4.

Might help....