topic Re: Closing body in Fusion Design, Validate & Document Forum

Closing body

klaasyperman — Thu, 29 Dec 2022 23:49:39 GMT

Dear all,

I am working on creating a 3d footswitch for changing music on an iPad but am unable to close the body at the top.

I would like to have a fluent transition between the different levels. So far I tried loft but was unable to get it to work.

Any tips would be helpful.

Kind regards

Klaas

Re: Closing body

jhackney1972 — Fri, 30 Dec 2022 01:30:13 GMT

I hope I have interpreted what you describe as "fluent". The top cover is created using surfaces. The middle fillet can be adjusted, right now it is 20 mm on the outside and 18 mm on the inside. Model is attached. Below is a Section Analysis turned on that is in the Browser.

Re: Closing body

klaasyperman — Sat, 31 Dec 2022 22:01:04 GMT

Dear John,

Thank you so much for your fast reply.

It also helped me to get better at Fusion360.

Kind regards

Klaas