topic Re: Hide the witness line on a construction line to keep the construction line visible in Fusion Design, Validate & Document Forum

Hide the witness line on a construction line to keep the construction line visible

Christoph_360 — Sat, 15 Jul 2023 14:19:19 GMT

Hello everyone

In the example, I measure a geometry with a construction line and the construction line is visible.

When I pull the massing to the other side, the construction line is no longer recognizable.

Is there a setting so that in such a case the witness line remains visible only outside the construction line.

Does anyone have any ideas?

Mfg

Christoph

Re: Hide the witness line on a construction line to keep the construction line visible

jhackney1972 — Sat, 15 Jul 2023 14:34:24 GMT

Sometimes you can drag the dimension extension line origin to another point but in this case it is better to erase the dimension and place it on the other side. The dimension extension line is covering the construction line.

Re: Hide the witness line on a construction line to keep the construction line visible

Christoph_360 — Sat, 15 Jul 2023 14:59:49 GMT

Hello

Thank you very much for your reply

I do it the same way, but there are cases where unfortunately it doesn't work.

For example, if I change the R1.0 to R1.10, the witness line of the measure fx: 0.20 jumps back to the top of the construction line and covers it again.

Mfg

Christoph

Re: Hide the witness line on a construction line to keep the construction line visible

g-andresen — Sat, 15 Jul 2023 15:06:19 GMT

Hi,

@Christoph_360 wrote:

Is there a setting so that in such a case the witness line remains visible only outside the construction line.

NO!

günther