topic Betreff: Continue groove along bend in Fusion Design, Validate & Document Forum

Continue groove along bend

swart79 — Sat, 22 Jul 2023 09:33:25 GMT

Hi,

i am creating a bumper filler for my car but I fail to finish the drawing because i cannot continue the grooves along the bent part of the piece on the right hand side. on the flat surface i managed to use extrusion. But the curve is the problem for me.

See picture of drawing in attachment

Can you help, please?

Thank you very much!

Re: Continue groove along bend

HughesTooling — Sat, 22 Jul 2023 10:27:27 GMT

Can you export the design as an f3d and upload here?

Re: Continue groove along bend

swart79 — Sat, 22 Jul 2023 11:25:23 GMT

Hi,

yes of course

see below

Betreff: Continue groove along bend

wersy — Sat, 22 Jul 2023 11:52:19 GMT

You could use "Sweep"

Betreff: Continue groove along bend

swart79 — Sat, 22 Jul 2023 12:11:42 GMT

I tried that but when I do it it looks like this:

Betreff: Continue groove along bend

swart79 — Sat, 22 Jul 2023 12:15:12 GMT

for some reason you could select the whole profile (3 surfaces) but I can only select one.

Is that maybe the problem?

Betreff: Continue groove along bend

swart79 — Sat, 22 Jul 2023 12:18:30 GMT

I got it. I have to select the projection surface on the correct side.

Thank you!

Solved.

Betreff: Continue groove along bend

jhackney1972 — Sat, 22 Jul 2023 12:31:40 GMT

Please take a look at this web article about accepting solutions for your post.

Betreff: Continue groove along bend

swart79 — Sat, 22 Jul 2023 12:59:25 GMT

done for both of you. Thanks a lot!