topic Re: Move a "derived sketch" in Fusion Design, Validate & Document Forum

Move a "derived sketch"

sandeepdutta — Mon, 28 Aug 2023 02:23:48 GMT

Is there a way to move a derived sketch ? I need to a create a single component

with two instances of a derived sketch . Any solution would be appreciated.

Thank you

Sandeep

Re: Move a "derived sketch"

HughesTooling — Mon, 28 Aug 2023 09:42:23 GMT

Create a component and with it active insert derive the sketch. Now you can position the component with a joint to move the sketch to the correct point.

Mark

Re: Move a "derived sketch"

sandeepdutta — Mon, 28 Aug 2023 15:04:11 GMT

Thank you, that worked. The quirk is that is does not derive the parameters if component is active, but

I derived another one at the top level to get the parameters and that worked as well.

Sandeep

Re: Move a "derived sketch"

HughesTooling — Mon, 28 Aug 2023 15:06:46 GMT

@sandeepdutta wrote:

Thank you, that worked. The quirk is that is does not derive the parameters if component is active, but

I derived another one at the top level to get the parameters and that worked as well.

Sandeep

Yes, I ran into that problem a few weeks ago, took me a while to figure out what the problem was!

Mark