Text Commands predictive text

Drewpan — Sun, 03 Sep 2023 02:57:10 GMT

Hi All,

I am discovering the joys of the Text Command box. Sketch.ShowUnderconstrained is making my life so

much easier as I don't have to hunt for missing constraints. I am not sure what a whole bunch of other text

commands are yet but I am going to have a good look at the list.

One thing I have noticed is that some of the commands are a little tricky to remember and easy to mis-spell.

Since these commands are a bunch of keywords and the actual command, I was wondering if predictive text

might be on the development plan? There are not a lot of them, so a simple lookup table should be easy to

program, and it would lead to less fails because you didn't get the spelling correct. Basically one table for the

keyword, like Sketch; it then recognises the full stop (point for my American cousins 😎) as the separator to

go to the custom command list for that keyword, like ShowUnderconstrained.

Any thoughts or am I just wanting to be lazy?

Cheers

Andrew

Re: Text Commands predictive text

TrippyLighting — Sun, 03 Sep 2023 09:22:58 GMT

Text commands are for advanced users.

Really advanced users don't need that command to figure out why a sketch isn't fully constrained. I've not used that command in 8 years of Fusion 360 use!

Re: Text Commands predictive text

Drewpan — Sun, 03 Sep 2023 09:52:44 GMT

I discovered if you use Tab that you sort of get it anyhow.

topic Text Commands predictive text in Fusion Design, Validate & Document Forum

Text Commands predictive text

Re: Text Commands predictive text

Re: Text Commands predictive text