topic The configuration table does not display configurations correctly in Fusion Design, Validate & Document Forum

The configuration table does not display configurations correctly

marcus.toepke — Fri, 01 May 2026 06:59:38 GMT

Hi all!

I've noticed that when you use configurations and eventually end up with a lot of them, they don't display correctly in the table.

When I scroll down, the last configuration appears briefly, but then gets pushed back down again! I have to start scrolling all over again to see the last configuration, and then it disappears again, as if pulled by a rubber band.

Re: The configuration table does not display configurations correctly

TrippyLighting — Sat, 02 May 2026 15:12:12 GMT

I have reposted in the EE Slack Channel to give it more visibility!

Re: The configuration table does not display configurations correctly

marcus.toepke — Sat, 02 May 2026 16:45:52 GMT

Thx!

But what is a EE Slack Channel?

Re: The configuration table does not display configurations correctly

TrippyLighting — Sun, 03 May 2026 21:07:43 GMT

Autodesk Expert Elite Slack channel. It allows Expert elites direct access to the development team.

I often post bugs there that I cannot post here on the forum, as all of my professional work in the manufacturing automation industry is under NDA.

BTW, the topic has received some attention there.

Re: The configuration table does not display configurations correctly

abhijeet.rajput — Mon, 04 May 2026 05:17:44 GMT

Hi Marcus,

Thanks for reporting.

We have already fixed the issue and we expect to get the fix out in May Release of the Fusion.

Regards,

Abhijeet Rajput

Autodesk Fusion.