topic Re: Sheet metal bending problem in Fusion Design, Validate & Document Forum

Sheet metal bending problem

rwootten33EHWC — Fri, 24 Apr 2026 00:49:10 GMT

I am try to bend to sides like a channel 90 degrees. But the ends of the channel edges are cut back grees to 80 degrees instead of them being perpedicular to the bend. Then they would have 90 degree bends so that part mounted to these surfaces will be tilted @ 80 Degrees. Here is a modeled image but it crashes when I try to create a flat pattern?

Re: Sheet metal bending problem

CCarreiras — Fri, 24 Apr 2026 08:53:15 GMT

Hi!

Well... we can do nothing with an image. What can we say?!

Post your part if you want us to inspect it...

Re: Sheet metal bending problem

Warmingup1953 — Sat, 25 Apr 2026 16:12:45 GMT

That doesn't look like a valid sheetmetal body. Can you share your Fusion file?

Re: Sheet metal bending problem

TheCADWhisperer — Mon, 27 Apr 2026 19:59:23 GMT

@rwootten33EHWC

Did you figure this out?

Re: Sheet metal bending problem

rosie_lucas1 — Thu, 30 Apr 2026 20:02:53 GMT

Hi @rwootten33EHWC,

I wanted to check in and see if you saw @Warmingup1953 and @TheCADWhisperer follow up questions and if assistance is still needed or if you found a solution to your question already? Please share any available information so the community can assist you further.

All the best,

Rosie | Community Manager