topic Re: Diplicate With Joints - flip feature request in Fusion Design, Validate & Document Forum

Duplicate With Joints - flip feature request

aleksei_ovsienko — Wed, 11 Mar 2026 16:47:58 GMT

Duplicate with joints is a great tool (if only we could also have duplicate with constraints).

But what sometimes happens is when you paste a duplicate it gets pasted upside down which break the workflow.
Could we please have a flip button in the Duplicate with joints dialogue?

Re: Diplicate With Joints - flip feature request

billbedford — Wed, 11 Mar 2026 12:00:24 GMT

Does this happen to all the duplicated joints? If so flip the original joint that is duplicated.

Re: Diplicate With Joints - flip feature request

aleksei_ovsienko — Wed, 11 Mar 2026 14:59:07 GMT

No. This happens randomly. I just now was inserting a washer into four counterbored holes. I inserted one, then did duplicate with joints. Went fine on the second hole. Then when I clicked on the third one the washer inserted upside down and into the body of the part. I had to stop duplicating, go into the joint and flip it. It's not an issue when you're doing 4 washers. But when you're doing 104 it sort of becomes annoying.

Re: Diplicate With Joints - flip feature request

jhackney1972 — Wed, 11 Mar 2026 15:56:19 GMT

The feature to Flip when using Duplicate with Joints is already currently available. I will show this in the attached Animated GIF.

Re: Diplicate With Joints - flip feature request

TrippyLighting — Thu, 12 Mar 2026 00:44:53 GMT

I re-posted this on the EE Slack channel, and I've been told that Duplicate with Constraints is in the works. No timeline was provided.