topic Re: Browser Tree naming Bug in Fusion Design, Validate & Document Forum

Browser Tree naming Bug

Drewpan — Wed, 27 Aug 2025 05:59:59 GMT

Hi All (and Devs),

I have noticed recently that when I rename stuff in the Browser Tree

that the names sometimes revert back to what they were before. I

haven't worked out a pattern yet but it typically goes along the lines

of rename Sketch X to Name Y; click on something else; then it reverts

back to Sketch X. I have noticed that if I name more than one thing

that sometimes two or more of the names revert back. It doesn't happen

EVERY time but it happens often. I have a complex design I am working

on and following the "Old?" RULE #1 (which seems to have gone MIA

from the Forum) Name Your Stuff, I have been doing so to help me

remember what things are to keep track of stuff. If this occurred only

sometimes I wouldn't worry too much about it but it is happening

quite regularly and getting frustrating.

Anyone else noticed this? I use standard settings so it isn't some Preference

that is doing it.

Cheers

Andrew

TheCADWhisperer — Wed, 27 Aug 2025 06:44:42 GMT

@Drewpan wrote:
Anyone else noticed this?

This behavior has been reported here in the past (I have observed the behavior).

Try renaming on Timeline rather than in browser.

TimelesslyTiredYouth — Wed, 27 Aug 2025 07:21:13 GMT

I've experienced it before but it only happened twice before it stopped.

Figured it was more of a local error, rather than a client side error on Fusion's side.

kind regards

Ricky