topic Re: CREATING SLATS FOR A CHAIR in Fusion Design, Validate & Document Forum

CREATING SLATS FOR A CHAIR

CPDR5Q9FEZFUPXSW24D2HR9H96XCTRGP9PV3KRTRT65RJ8ANKE5K2H3Z — Mon, 07 Jul 2025 19:57:03 GMT

I am designing a chair with curved slats that are connected to supports that are not parallel. They are both 5 degrees off parallel from front to back. The supports have a stopped rabbet in which the slats terminate, therefore each slat will have a 5-degree cut on each end. my question is: How do i get the slats to follow the bottom of the stopped rabbet in order to create a smooth curved seat. Any assistance would be greatly appreciated. Joseph

Re: CREATING SLATS FOR A CHAIR

Warmingup1953 — Mon, 07 Jul 2025 20:10:22 GMT

Can you share your Fusion file?

Re: CREATING SLATS FOR A CHAIR

TheCADWhisperer — Mon, 07 Jul 2025 20:35:03 GMT

@CPDR5Q9FEZFUPXSW24D2HR9H96XCTRGP9PV3KRTRT65RJ8ANKE5K2H3Z

Are there any unresolved issues highlighted in your Timeline?

Re: CREATING SLATS FOR A CHAIR

CPDR5Q9FEZFUPXSW24D2HR9H96XCTRGP9PV3KRTRT65RJ8ANKE5K2H3Z — Sat, 19 Jul 2025 21:18:48 GMT

Thank you for responding.
I would like to share my drawing with you, but I do not have a commercial license. I have a model that I’ve been working on today. That will show you what I’m trying to do. If it is at all possible, I would like to share it with you and the timeline.
Sorry it’s been so long in responding. I work a very strenuous job during the day.
I look forward to hearing from you and your assistance.

Re: CREATING SLATS FOR A CHAIR

TheCADWhisperer — Sat, 19 Jul 2025 21:59:54 GMT

@CPDR5Q9FEZFUPXSW24D2HR9H96XCTRGP9PV3KRTRT65RJ8ANKE5K2H3Z

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?