topic Cube view orientation clocked from part orientation in Fusion Design, Validate & Document Forum

Cube view orientation clocked from part orientation

matthew — Mon, 15 Dec 2014 18:55:38 GMT

I was wondering if the origin can be rotated according to the orientation cube in the upper right corner of the Fusion window? If you take a look at the screen shot I have sent, you will notice the green line (Y positive) points in the Y positive direction only when the orientation cube is clocked -90 degrees. I believe this is causing rotational issues in the 3+2 machining.

Re: Cube view orientation clocked from part orientation

HughesTooling — Mon, 15 Dec 2014 19:14:40 GMT

Hi Matthew

Take a look at this thread.

http://forums.autodesk.com/t5/general-fusion-360-questions/layout-orientation/td-p/5438998

Mark