topic Re: Edge banding: workflow suggestions in Fusion Design, Validate & Document Forum

Edge banding: workflow suggestions

tookemtoni — Thu, 26 Oct 2023 06:33:11 GMT

We’re starting to use a lot more edge banding.

How can you communicate to the workshop where the edge banding goes?

Note:

The workshop uses an Edge Banding Machine that removes the EB thickness from the destination piece and then installs the edge banding…so I don’t have to take an account for the edge banding dimension or model it. I would most likely just change the appearance of the face to represent the edge banding.

Betreff: Edge banding: workflow suggestions

wersy — Thu, 26 Oct 2023 07:27:39 GMT

To show where the edge banding goes, you must first design the furniture.

Re: Edge banding: workflow suggestions

tookemtoni — Thu, 26 Oct 2023 15:28:25 GMT

😂

Re: Edge banding: workflow suggestions

TrippyLighting — Thu, 26 Oct 2023 15:40:10 GMT

@tookemtoni wrote:

...

How can you communicate to the workshop where the edge banding goes?

...

We can probably give you recommendations based on our experience in manufacturing, approaching about 4 decades in my case. But that might not reflect your situation.

I think you need to strike a balance between what the folks on the shop floor that do the actual manufacturing work, and what is possible in Fusion 360. Have you talked to those folks ?

Re: Edge banding: workflow suggestions

tookemtoni — Fri, 27 Oct 2023 14:28:07 GMT

Thanks @TrippyLighting, I making the switch to 100% Fusion so I am excited to see if there is a better way than how we do it today.

The hope of this post hear what other professionals using Fusion were doing to communicate with their shops about edge banding.

Re: Edge banding: workflow suggestions

g-andresen — Fri, 27 Oct 2023 15:30:47 GMT

Hi,

in the screencast I show 2 procedures

(view in My Videos)

günther

Re: Edge banding: workflow suggestions

Warmingup1953 — Fri, 27 Oct 2023 17:45:20 GMT

Certainly worth a look is a PAID add-in JoinerCAD. I have only trialed it so I am by no means an expert.

Short intro tutorial:

https://youtu.be/bH4orncED_Y?si=OQR-AZIGmPgl-c9T

I assume because you have a milling edgebander you are a larger Enterprise? That being the case you'll be needing an Automated approach to communication to the shop floor. At a company I work with on projects we use Microvellum. This sits atop an Autocad Licence (Not Fusion 360 unfortunately!) and it generates labels that communicate on the shop floor: