topic Re: Hole references bug in March 2015 in Fusion Design, Validate & Document Forum

Hole references bug in March 2015

flash691 — Sun, 15 Mar 2015 21:39:20 GMT

I added a hole to a face that is 1" wide and wanted to center it. If I select the right side to add a reference for .5" it shows up fine during edit, but when I hit ok, the hole moves .5" to the right of what is being referenced. I've attached some screen clips to show what its doing. When editing the hole, it reverts back to the way it is intended. The work around is to set the references to move the hole into the desired place and then delete the references.

Re: Hole references bug in March 2015

jeff_strater — Sun, 15 Mar 2015 22:10:13 GMT

yes, that is a bug. Would it be possible to share your design, so we could take a closer look?

To work around it, create a sketch on that face, and place a sketch point, then dimension it using sketch dimensions. You can select the sketch point as the hole center, and it will keep that relationship

hope this helps you in the short term

Jeff Strater (Fusion development)

Re: Hole references bug in March 2015

flash691 — Sun, 15 Mar 2015 22:24:49 GMT

Sure, here's the link http://a360.co/1EhTHsB

Thanks,

Robbie