topic Re: Issue saving project files in latest release of Fusion in Fusion Design, Validate & Document Forum

Issue saving project files in latest release of Fusion

Anonymous — Thu, 13 Aug 2015 15:42:06 GMT

After updating to Fusion 2.0.1591 I'm experience an issue where if I create a new project document, create a body in it, and go to save it will either :

1. Attempt to save where I will see the new project document in the project folder but when I go outside of the project folder and back in the document is no longer there. Also, may just disappear on its own.

2. The document is there but I get an error from fusion saying it is unable to open the document and to try again later.

I've tried multiple times with the same results. I have also tried restarting Fusion with no change in behaviour. The host machine is a Macbook Pro i7 w 16GB ram and lots of free disk space. Running OSX ver. 10.10.4

I have the log files available.

Any help will be appreciated.

Pete

Re: Issue saving project files in latest release of Fusion

Anonymous — Thu, 13 Aug 2015 16:07:51 GMT

I logged in under Windows 7 on the same machine and tried the same version of Fusion 360 (ver. 2.0.1591) and I cannot replicate the issue. So it seems that the saving issue only occurs under OSX.

Pete

Re: Issue saving project files in latest release of Fusion

innovatenate — Fri, 14 Aug 2015 00:36:22 GMT

Can you forward your the pertinent log files to me at nathan.chandler@autodesk.com and clarify the name of the design in question?

Thanks,

Re: Issue saving project files in latest release of Fusion

Anonymous — Fri, 14 Aug 2015 13:37:46 GMT

Sure, I'll swtich over to OSX and grab the log files and send them to you shortly. I'll also re-test once under OSX.

Pete

Re: Issue saving project files in latest release of Fusion

innovatenate — Tue, 25 Aug 2015 17:43:42 GMT

In case anyone else runs into this issue, the solution is documented in the below link.

http://forums.autodesk.com/t5/design-and-documentation/copy-design-amp-drawings/m-p/5780959#M31129

Thanks,