topic Re: Tool path error in Fusion Design, Validate & Document Forum

Tool path error

Anonymous — Sat, 21 Nov 2015 02:53:19 GMT

My tool paths are above and below selected 3/4 stock.

New at this and could use some help.

THANKS

Re: Tool path error

Bud_Schroeder_ADESK — Sat, 21 Nov 2015 03:44:44 GMT

Hi Ken,

Thanks for posting to the forum. I'm going to move your post to the Fusion forum so that the right team can help out with your tool path question.

Hope this helps.

Re: Tool path error

Anonymous — Sat, 21 Nov 2015 17:30:00 GMT

Thank you

Ken

Please note when replying via email any signature used by your email client will be added to your post as with any other email.
Please be aware that this is a public forum posting serial numbers or personal information is not advised

Edited by
Discussion_Admin

Re: Tool path error

HughesTooling — Sat, 21 Nov 2015 09:41:21 GMT

On the Heights tab for the Top Height select model top and for Bottom Height select Model Bottom. You could select Stock Top and Stock bottom as long as you have them set coretly in the setup.

Mark

Re: Tool path error

Anonymous — Sun, 22 Nov 2015 21:01:33 GMT

Did no change the proplem

Re: Tool path error

HughesTooling — Sun, 22 Nov 2015 21:03:37 GMT

Can you export the file as an f3d and attach to this thread. From the File Menu select Export.

Thanks Mark

Re: Tool path error

Anonymous — Sun, 22 Nov 2015 22:02:44 GMT