topic Re: joint perpendicular surfaces in Fusion Design, Validate & Document Forum

joint perpendicular surfaces

Anonymous — Wed, 16 Dec 2015 15:16:23 GMT

as showed in the picture I need to joint the two surfaces selected.

any help?

Re: joint perpendicular surfaces

innovatenate — Wed, 16 Dec 2015 23:48:13 GMT

Can you use the Assemble Joints or As-built Joint command to accomplish this task? Another command that may help is the Rigid Group command from the assembly drop down menu.

The screenshot is a bit too small side to see what is happening. Perhaps you could share a public link of the design?

Thanks,

Re: joint perpendicular surfaces

Anonymous — Thu, 17 Dec 2015 09:41:29 GMT

yes, you're right, using a different combination of joints I can obtain what I need.

it's quite interesting because this kind of problems help me to to think about the design stimulating new solutions. thank you!