topic Re: Odd behavior with the push-pull function. in Fusion Design, Validate & Document Forum

Odd behavior with the push-pull function.

Oceanconcepts — Wed, 13 Jan 2016 01:31:37 GMT

Any ideas what might be happening here? One side of the part works normally, the other distorts using Push-pull.

Re: Odd behavior with the push-pull function.

jeff_strater — Wed, 13 Jan 2016 01:55:12 GMT

My guess is that these two faces are not the same geometry. The first face you Press/Pull looks planar, while the second looks like it might be a spline face. Offset of a spline face can be a challenge - depending on the geometry of the face the offset can easily distort like you are seeing it here. What feature was used to create these faces?

Jeff

Re: Odd behavior with the push-pull function.

Oceanconcepts — Wed, 13 Jan 2016 04:33:40 GMT

The two sides were created with the same sketch, defined by a line (not a spline). I tried saving a copy of the component, but got a message that A360 was unable to process it, and it has now disappeared from my data panel- though it did show just after I saved it. I modified the offfending face with primitives to continue the design, so it was just a momentary glitch.

Unfortunately the example is now lost.