topic Appearance Function - Component Color Error in Fusion Design, Validate & Document Forum

Appearance Function - Component Color Error

nickfabb — Tue, 16 Feb 2016 22:04:57 GMT

I am trying to change the appearance to look as follows (first image) but receive the error in the bottom right. Component Color Cycling has been disabled temporarily. The desired appearance only shows up when in the appearance window. As soon as I click close the second image is what it reverts to. It must be selecting some default colors for each component? I need to get the selections to stick while editing the model. Please advise. Thank you!

Re: Appearance Function - Component Color Error

jeff_strater — Tue, 16 Feb 2016 23:54:49 GMT

I think the error messages are the clue here. You have somehow turned on this "Component color cycling" mode. Quite likely this is because the "n" key is a hotkey for this, and you may have accidentally hit it at some point.

To disable this mode, either hit "n" again, or go to this dropdown:

Jeff Strater (Fusion development)

Re: Appearance Function - Component Color Error

nickfabb — Wed, 17 Feb 2016 00:26:05 GMT

Thanks that was it. If only the error message was a little more insightful. 🙂