topic Re: How can I fix pattern fold errors in 123D Make? in Fusion Design, Validate & Document Forum

How can I fix pattern fold errors in 123D Make?

Anonymous — Mon, 29 Feb 2016 21:45:50 GMT

Using 123D Make to play with a 3D model that I want to built. I want to create a pattern fold that I can then output to PDF and then print and transfer to either cardboard or foam. But I get a pattern fold error that says that the pattern fold is too big for the 8 1/2x11 paper. OK I get that. It is. But why doens't 123D just put the rest of it on another page? How do I break it up so that I can output this and move on? I'm running up against a wall here.

Any help you guys can offer is appreciated!

Re: How can I fix pattern fold errors in 123D Make?

TrippyLighting — Mon, 29 Feb 2016 22:10:36 GMT

I just wanted to make you aware that posted this on the Fusion 360 form, not the 123D Make forum

Re: How can I fix pattern fold errors in 123D Make?

Anonymous — Mon, 29 Feb 2016 22:47:18 GMT

Ooops. I thought it was a general AutoDEsk forum! Thanks! I'll repost.

Re: How can I fix pattern fold errors in 123D Make?

TrippyLighting — Mon, 29 Feb 2016 22:52:01 GMT

On the other hand, you could also just ditch 123d Make and move over to Fusion 360 😉

Re: How can I fix pattern fold errors in 123D Make?

innovatenate — Mon, 29 Feb 2016 23:27:23 GMT

You may try posting in the 123D Help Center, below.

https://support.123dapp.com/hc/en-us

Hope that helps!

Thanks,