topic Re: Parts collide in simulation in Fusion Design, Validate & Document Forum

Parts collide in simulation

Anonymous — Tue, 29 Mar 2016 19:01:19 GMT

I have ran a simulation between two bodies and its showing the two parts. They are passing the part boundraies that could affect the simulation outcome. I tried to add a contact of sepration and sliding. Is this right and how do I stop it?

Re: Parts collide in simulation

josef.kucera — Tue, 29 Mar 2016 19:40:40 GMT

Hi @Anonymous,

here is a link where you can learn more about contact types: http://fusion360.autodesk.com/learning/learning.html?guid=GUID-B43E60CD-1859-4A09-9AD4-394525DAA2D7

For instance if bonded contact were made between two bodies/components (two faces) they should not penetrate/collide to each other.

The penetration could happen if a deformation scale is too big, try to set up deformation scale to Adjusted.

Regards,

Josef

Re: Parts collide in simulation

Anonymous — Tue, 19 Apr 2016 13:59:48 GMT

Similar issue.

I have parts passing through each other:

I have set contact surfaces to separate and slide.
I have tried adjusted.

Re: Parts collide in simulation

josef.kucera — Tue, 19 Apr 2016 14:39:02 GMT

Hi @Anonymous,

could you share your design so we can look what's wrong?

You can DM me to josef[dot]kucera[at]autodesk[dot]com.

here is a tip how you can share your design: https://knowledge.autodesk.com/support/fusion-360/troubleshooting/caas/sfdcarticles/sfdcarticles/How-to-share-a-Fusion-360-design.html

Regards,

Josef