topic Does anyone here feels that the fusion 360 is dictating him in Fusion Design, Validate & Document Forum

Does anyone here feels that the fusion 360 is dictating him

Anonymous — Sat, 16 Jul 2016 15:42:56 GMT

Im kinda not satisfied using the fusion 360 because sometimes i kinda frustrated like for example i want a 10 mm corner fillet but the software wont allow me. well in fact i can do it in other software. one of the most thing that frustrate me is that you cannot blend corners with different fillet value

Re: Does anyone here feels that the fusion 360 is dictating him

HughesTooling — Sat, 16 Jul 2016 16:14:54 GMT

How about attaching some samples, f3d files or screen grabs.

@Anonymous wrote:

one of the most thing that frustrate me is that you cannot blend corners with different fillet value

Do you mean something like this.

Mark

Re: Does anyone here feels that the fusion 360 is dictating him

Anonymous — Sun, 17 Jul 2016 00:47:47 GMT

This is what i want so that the intersection of all the fillet will blend.

see the difference between the screen shot i uploaded

Re: Does anyone here feels that the fusion 360 is dictating him

TrippyLighting — Sun, 17 Jul 2016 02:55:52 GMT

I don't know how you managed to do that, but it works fine here just as @HughesTooling shows in his screenshot.

You may want to create a screencast not just showing the end result, but how you actually created that fillet.

Re: Does anyone here feels that the fusion 360 is dictating him

Anonymous — Sun, 17 Jul 2016 05:53:30 GMT

this is how i use fillet

Re: Does anyone here feels that the fusion 360 is dictating him

HughesTooling — Sun, 17 Jul 2016 11:13:03 GMT

You need to select all the edges to fillet in one go. If you want to use Press\Pull hold the Ctrl key down to add to the selection or if you use the fillet tool just select all the edges before entering a size for the radius.

Select all edges while the fillet is set to zero.

That said the blend Fusion creates is not the same as your example, it adds a setback that you might not want.

It looks OK if you turn off the display of edges though.

I tested in another program and got the same as your sample so if this is something you need add a request to the Ideastation.

Mark

Re: Does anyone here feels that the fusion 360 is dictating him

Anonymous — Mon, 18 Jul 2016 03:18:31 GMT

yap thanks