https://forums.autodesk.com/t5/fusion-design-validate-document/fusion-ad-print-studio-and-ultimaker2/m-p/6491201#M248068 <P>Anybody has some experience with ADPS when using an Ultimker2+?</P> <P>&nbsp;</P> <P>I mainly use CURA but it is a pretty slow application when using large models (slicer takes ages)</P> <P>and it only can make one type of supports.</P> <P>&nbsp;</P> <P>There is also Craftware where I think you can generate most of the needed gCODE and then use the head and foot from a Cura generated document.</P> <P>&nbsp;</P> <P>Anyone used Craftware here?</P> Wed, 10 Aug 2016 12:26:26 GMT cekuhnen 2016-08-10T12:26:26Z https://forums.autodesk.com/t5/fusion-design-validate-document/fusion-ad-print-studio-and-ultimaker2/m-p/6491201#M248068 <P>Anybody has some experience with ADPS when using an Ultimker2+?</P> <P>&nbsp;</P> <P>I mainly use CURA but it is a pretty slow application when using large models (slicer takes ages)</P> <P>and it only can make one type of supports.</P> <P>&nbsp;</P> <P>There is also Craftware where I think you can generate most of the needed gCODE and then use the head and foot from a Cura generated document.</P> <P>&nbsp;</P> <P>Anyone used Craftware here?</P> Wed, 10 Aug 2016 12:26:26 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/fusion-ad-print-studio-and-ultimaker2/m-p/6491201#M248068 cekuhnen 2016-08-10T12:26:26Z