topic Re-visiting my tubing structure creation failures. in Fusion Design, Validate & Document Forum

Re-visiting my tubing structure creation failures.

kshea9RNL8 — Sat, 29 Oct 2016 00:35:17 GMT

This was one of the first things attempted and Browny actually got me moving in the right direction, having got side tracked am now revisiting I find it's all forgotten .

Keeping it simple with a rectangular shape frame using round tubing and one inside corner to another diagonal tube.

What I want to end up with is the 5 hollow tubes being isolated components and fully coped to the mating tubes, not just looking coped from the outside but properly shaped where they meet up to their mating tube.

So far just spinning my wheels and creating crashes.

Any ideas on a method to accomplish this?

Re: Re-visiting my tubing structure creation failures.

Beyondforce — Sat, 29 Oct 2016 03:48:46 GMT

Hi @kshea9RNL8,

Will you please make a screencast? it will be much easier to understand your challenge.

Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

Check out my YouTube channel: Fusion 360: Newbies+

Re: Re-visiting my tubing structure creation failures.

davebYYPCU — Sat, 29 Oct 2016 21:50:27 GMT

Gooday Ken,

Been some water under the bridge since those days, have checked,

our old Threads are still available, searching old threads, click on your name in the left column, the view all posts you have made,

about page 10, was a couple mentioning Pipe commands, the old screencast still works,

Send a Pm if you like, can catch up behind the scenes.....

Re: Re-visiting my tubing structure creation failures.

kshea9RNL8 — Sat, 29 Oct 2016 22:32:56 GMT

Ah, forgot about those Browny, I'll check them out tonight, thanks.

Re: Re-visiting my tubing structure creation failures.

kshea9RNL8 — Sun, 30 Oct 2016 09:47:06 GMT

For anyone with need for additional information there are a couple of very good screen cast on the tube command use by Brownie ( davebYYPCU ) and Louis ( lnonnato )at this link.

https://forums.autodesk.com/t5/design-validate-document/help-using-the-pipe-command/td-p/6336480