topic Re: Trouble selecting geometry for offset in Fusion Design, Validate & Document Forum

Trouble selecting geometry for offset

jeffescott — Thu, 07 Mar 2024 01:09:10 GMT

I created a sketch, I projected the geometry. I sketch an outer box. I tried to select the projected geometry but i was only able to select one of the lines. I traced the projected lines and tried again, i could only select one line. I tried ctrl select and alt select no luck. What to I have to do.

See attached file component Latch lever:1 subcomponent lever pad:1 Sketch 1. I am trying to select the inner quadrilateral with an arc.

What am i doing wrong

Re: Trouble selecting geometry for offset

jhackney1972 — Thu, 07 Mar 2024 01:33:15 GMT

If the picture reflects what you are trying to do, then you must Offset three entities, the two projected lines at an angle and the center arc.

Re: Trouble selecting geometry for offset

jeffescott — Thu, 07 Mar 2024 01:43:40 GMT

yup

@jeffescott wrote:
I created a sketch, I projected the geometry. I sketch an outer box. I tried to select the projected geometry but i was only able to select one of the lines. I traced the projected lines and tried again, i could only select one line. I tried ctrl select and alt select no luck. What to I have to do.
See attached file component Latch lever:1 subcomponent lever pad:1 Sketch 1. I am trying to select the inner quadrilateral with an arc.
What am i doing wrong

you got it but why won't it select... I just created another geometry, and set it in the box....that selected fine?