topic Re: discontinuity in Fusion Design, Validate & Document Forum

discontinuity

Anonymous — Thu, 15 Dec 2016 20:56:58 GMT

how can solve this discontinuity problem

it is a very bad area, because I haen't a tangensy surface

the transition is too "dry"

as you can adjust the transition from edge so soft

for example, in software like IMA is possible to change strain in the point

Re: discontinuity

colin.smith — Fri, 16 Dec 2016 16:21:54 GMT

Hi @Anonymous,

There are a couple ways you can handle a transition like this.

Take a look at this screencast. http://autode.sk/2h8Owrg

Hope that helps.

Colin

Re: discontinuity

Anonymous — Mon, 19 Dec 2016 09:49:46 GMT

hi Collin
thanks for your great help.
I used a solution similar to yours.

in your opinion in the future is possible to change strain in the point like IMA?

Re: discontinuity

colin.smith — Mon, 19 Dec 2016 14:14:35 GMT

@Anonymous

Glad that helped. The only way to get a more natural fall of in SubD modeling that I have seen is using weighted edges/verts. We have it in our backlog but I don't know at this point when it will show up in the product.

Cheers,

Colin