I am trying to make a loft solid but it wont work

carlweitman50 — Sun, 24 Mar 2024 19:57:17 GMT

Hello. I am trying to design an airplane vertical stabilizer, by lofting two airfoils with guide rails. However, when i do it, the loft doesnt turn the vertical stabilizer into a solid. Is there any way to loft it or to later turn it into a solid?

The file is quite messy, so im going to explain which sketches i am trying to loft:

The loft is from the sketch called vertical stabilizer 1 to vertical stabilizer two. The rails are in a sketch called vertical stabilizer guide rails.

Any help would be deeply appreciated!

Kind Regards,

Carl

Re: I am trying to make a loft solid but it wont work

jhackney1972 — Sun, 24 Mar 2024 20:16:38 GMT

I attached your model with what I think you are describing for the loft.

topic Re: I am trying to make a loft solid but it wont work in Fusion Design, Validate & Document Forum

I am trying to make a loft solid but it wont work

Re: I am trying to make a loft solid but it wont work