topic Re: miter a sketch rectangle in Fusion Design, Validate & Document Forum

miter a sketch rectangle

Anonymous — Wed, 18 Jan 2017 02:26:03 GMT

Can someone tell me how to miter this slanted rectangle up on the left side so that the top and bottom lines go perpendicular to the main piece while retaining the angle?

Re: miter a sketch rectangle

etfrench — Wed, 18 Jan 2017 02:46:09 GMT

Can you edit the screenshot and add some red lines where the miter should go.

Re: miter a sketch rectangle

Anonymous — Wed, 18 Jan 2017 08:54:59 GMT

Yes I can.

How do I do that?

Re: miter a sketch rectangle

etfrench — Wed, 18 Jan 2017 09:05:54 GMT

Paintbrush, Photoshop, etc.

Re: miter a sketch rectangle

Anonymous — Wed, 18 Jan 2017 22:47:30 GMT

Ok I thought maybe there was something in Fusion 360

Re: miter a sketch rectangle

etfrench — Thu, 19 Jan 2017 01:03:01 GMT

Assuming the vertical and horizontal lines are in the same sketch as the tilted rectangle, you can use the trim command to remove the unwanted rectangle parts. If they are not in the same sketch, then you can use the project command to create them in the tilted rectangle sketch.