topic Re: Question in Fusion Design, Validate & Document Forum

Question

Anonymous — Fri, 03 Feb 2017 14:25:17 GMT

Hi! I am designing a board and I am trying to figure out how to make an arc that is embedded into the body. The reason I am doing that is because I am trying to make a dry erase marker holder where my marker would fit well. How can I do so without taking too many steps and confusing myself throughout the process?

- Thanks

Re: Question

robduarte — Fri, 03 Feb 2017 14:30:36 GMT

Post a pencil sketch of what you're looking to do - it's hard to answer with the description you gave.

Re: Question

Anonymous — Fri, 03 Feb 2017 14:53:22 GMT

I am asking how I can make a dry erase marker holder like one used with
whiteboards but shaped like an arc embedded into my object if that makes
sense. Here is the sketch:

Re: Question

robduarte — Fri, 03 Feb 2017 15:33:20 GMT

I think the attachment didn't make it.

Re: Question

Anonymous — Fri, 03 Feb 2017 16:31:03 GMT

Oh sorry. I dont know what else I should send but I can try sending the
detachment again

Re: Question

HughesTooling — Fri, 03 Feb 2017 16:38:24 GMT

@Anonymous Email attachment don't come through, you'll have to use the forum.

Mark

Re: Question

robduarte — Fri, 03 Feb 2017 17:00:38 GMT

I edited my previous reply but I guess it didn't get saved. What I said was, if you're essentially trying to make a single body that looks like a capital letter J from the side (which is what I'm imagining from your description), then I'd suggest making a sketch that looks like a capital letter J. Then extrude that profile. Here's the basic idea: https://youtu.be/ed43kU3jtg0