topic Re: Multiple move copy in Fusion Design, Validate & Document Forum

Multiple move copy

Anonymous — Wed, 08 Feb 2017 10:06:51 GMT

In the case of spiral stair treads.

Can I copy and move and rotate in a single operation for multiple treads.

At the moment I am modelling the lowest tread.

Then copying/moving that tread to the next level.

Then rotating it to suit the spiral.

Then repeating this process for each tread thereafter.

I,m assuming there is a more productive approach. Maybe someone can

point me in the right direction.

Thanks.

tim

josef.kucera — Wed, 08 Feb 2017 14:25:59 GMT

Hi @Anonymous,

this older thread may be help you:

Regards,

Josef

Anonymous — Wed, 08 Feb 2017 19:43:48 GMT

Thanks,

But as a novice at Fusion360, scripting is a bridge too far for me at the moment.

I,ve only used Fusion for the past couple of weeks.

Tim

josef.kucera — Wed, 08 Feb 2017 19:52:25 GMT

If you read through the whole thread you will notice that there are also other advices how to create a stairs parametrically in the Fusion...

Hope it helps.

Regards,

Josef

Anonymous — Wed, 08 Feb 2017 22:16:25 GMT

Thanks..

Other options are written by more knowledgeable Fusion advocates than I am.

I,m not up to speed on the parametric attributes or avenues in Fusion after only a couple of

weeks I,m afraid, but I,ll keep looking.

Thanks

Tim