topic Re: Connecting Pipe Fittings Without Interference in Fusion Design, Validate & Document Forum

Connecting Pipe Fittings Without Interference

tonyj.moore — Thu, 23 Feb 2017 05:18:40 GMT

So I have been reading post after post about joining bodies and components but I have not found anything specific to my issue. I am trying to attach pipe nipples and valves together that have been downloaded from the McMaster Carr Catalog. I can align the components correctly but when I check for interference between the two, it always shows some interference even after rotating and moving the components up and down. I have attached some screen shots.

Thanks!

Tony

Re: Connecting Pipe Fittings Without Interference

Beyondforce — Thu, 23 Feb 2017 15:06:24 GMT

Hi @tonyj.moore,

Check out this video, it will might help you: https://www.youtube.com/watch?v=APaQ5pPLY8A

Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

Check out my YouTube channel: Fusion 360: NewbiesPlus

Re: Connecting Pipe Fittings Without Interference

tonyj.moore — Thu, 23 Feb 2017 15:56:07 GMT

Thanks for the reply! That helped out big time. Apparently I was searching using the wrong verbiage.

Re: Connecting Pipe Fittings Without Interference

Beyondforce — Thu, 23 Feb 2017 15:57:44 GMT

Great, I'm glad I could help!

Ben.