topic Re: Dimension Tolerance Limitations in Fusion Design, Validate & Document Forum

Dimension Tolerance Limitations

Anonymous — Tue, 07 Mar 2017 09:28:43 GMT

Hi,

I am having a problem with tolerances.

I can add a dimension to my drawing, but when I try to add a tolerance to that dimension (in this particular case 14.7 plus or minus 0.5) the tolerance shows up in the drawing as 14.7 plus or minus 0

I.E. no ".5" - it only accepts whole numbers.

I can enter 14.7 plus or minus 1, 2, 3 etc. without a problem. 14.7 plus or minus 1.9 shows up as 14.7 plus or minus 1

What gives? I need the digits after the decimal place.

Fusion updated twice during this last week - without any error messages.

Regards,

Brett Clausen

Re: Dimension Tolerance Limitations

Anonymous — Tue, 07 Mar 2017 09:55:36 GMT

Hi,

Never mind, brain's on slo-mo.

Just after I pushed the button to post the last message, I had a thought - Restarting Fusion sorted out the problem.

Regards,

Brett

Re: Dimension Tolerance Limitations

christophe.bourassaKGDWQ — Wed, 04 Oct 2017 19:31:28 GMT

Hi,

I have the same problem, at random moment. Happen sometimes without reason, sometimes there's no problem. Start to be frustrating to restart Fusion every time I want to had a tolerance. Is that bug have been reported to the programmer ?

Thanks