topic extending a fillet not possible in Fusion Design, Validate & Document Forum

extending a fillet not possible

Anonymous — Sun, 26 Mar 2017 09:53:09 GMT

Hi all,

as seen on the screenshot I have applied a fillet on the blue highlighted edge. However, later I was extending the edge and I like to apply the fillet to rest of the edge now which fails/is not possible. I tried to delete the first fillet in order to apply it again to the whole edge, however, that creates some warning and error along mit history line.

Any thoughts how I can resolve this issue?

Thanks a lot!!

Re: extending a fillet not possible

Anonymous — Sun, 26 Mar 2017 10:01:42 GMT

Did you try to open this fillet for edit and add that rest piece of edge (Ctrl+Click on it)?

Re: extending a fillet not possible

Anonymous — Sun, 26 Mar 2017 18:29:04 GMT

Hi GrAndAG,

thank you so much for your input. Concerning your question: No, since the first part is being created way earlier on the history timeline compared to the second I am unable to select the rest when editing the first part. I played around with it a bit more an noticed that when I try to apply the filled to the second part (1mm) it complains about the size. So I played around with the size and was able to apply 0.9999mm to it which I hope will not be noticeable in the end.

Cheers