topic Removing Material in Fusion Design, Validate & Document Forum

Removing Material

daniel.rindt — Wed, 26 Apr 2017 08:50:22 GMT

Hello,

i try to remove material which previously created by a loft. The cut should exactly remove the room between the 2 faces you can see in the attachment. I could use the extrusion with "cut" option selected but how to calculate the tamper angle then? If that is the way i should go.

Thank you a lot,

Daniel

Re: Removing Material

davebYYPCU — Wed, 26 Apr 2017 09:01:04 GMT

I would use the Modify > Shell command. and clicking on top and bottom faces, will remove those faces,

But if you want to keep the faces, select the body in the browser

Re: Removing Material

daniel.rindt — Wed, 26 Apr 2017 09:06:33 GMT

I need the room between both profiles, the reason is that it's not a square, its conical.

Re: Removing Material

TrippyLighting — Wed, 26 Apr 2017 10:15:37 GMT

Have you tired the shell command as suggested ?

i am not sure i understand your last post. If you only need the upper, or lower part hollowed, then you can make a second loft and use Modify-> combine-cut

Re: Removing Material

davebYYPCU — Wed, 26 Apr 2017 10:19:11 GMT

This any better? Loft with cut.