https://forums.autodesk.com/t5/fusion-design-validate-document/question-about-pipes/m-p/7176677#M199562 <P>Greetings all,</P><P>&nbsp;</P><P>I was curious if there was a way within Fusion to intelligently automate creating a pipe/tube. I have a project in which I need to cram as much tubing/piping into a given volume with specific start and end points. Is this possible? Will it involve a lot of custom scripting? Did I post this in the correct place on the forum?</P><P>&nbsp;</P><P>Thank you</P> Sun, 25 Jun 2017 05:03:36 GMT Anonymous 2017-06-25T05:03:36Z https://forums.autodesk.com/t5/fusion-design-validate-document/question-about-pipes/m-p/7176677#M199562 <P>Greetings all,</P><P>&nbsp;</P><P>I was curious if there was a way within Fusion to intelligently automate creating a pipe/tube. I have a project in which I need to cram as much tubing/piping into a given volume with specific start and end points. Is this possible? Will it involve a lot of custom scripting? Did I post this in the correct place on the forum?</P><P>&nbsp;</P><P>Thank you</P> Sun, 25 Jun 2017 05:03:36 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/question-about-pipes/m-p/7176677#M199562 Anonymous 2017-06-25T05:03:36Z https://forums.autodesk.com/t5/fusion-design-validate-document/question-about-pipes/m-p/7176689#M199563 <P>@Anonymous</P> <P>&nbsp;</P> <P>You want to put a certain amount of pipes into a volume? Then no there is no automated pipe tool in fusion for that.</P> <P>&nbsp;</P> <P>but still can yo share a screenshot?</P> Sun, 25 Jun 2017 06:07:16 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/question-about-pipes/m-p/7176689#M199563 cekuhnen 2017-06-25T06:07:16Z