topic Re: Creating round head bolt in Fusion Design, Validate & Document Forum

Creating round head bolt

harishjangrasiit1 — Fri, 03 Nov 2017 14:45:57 GMT

I was trying to create round head bolt. I extruded a square to create a square bolt head but now i have to make it round. I tried fillet but didn't get the results

Re: Creating round head bolt

sanjay_jayabal — Fri, 03 Nov 2017 15:11:34 GMT

Hi,

Would you be able to share the design? Also, if it is a standard bolt, you might want to try the McMaster Carr support in Fusion. Go to Insert > Insert McMaster-Carr component, search for the type and size you need and insert the 3d design.

Best regards,

Sanjay Jayabal.

Re: Creating round head bolt

SaeedHamza — Fri, 03 Nov 2017 15:37:11 GMT

Sketch a circles, and then extrude cut the area of the edges

Regards

Re: Creating round head bolt

harishjangrasiit1 — Sat, 04 Nov 2017 09:56:58 GMT

here is the design

Re: Creating round head bolt

lichtzeichenanlage — Sat, 04 Nov 2017 11:28:35 GMT

My solution: Sketch the profile (half) and revolve it

Re: Creating round head bolt

TheCADWhisperer — Sat, 04 Nov 2017 19:53:49 GMT

The image you attached does not depict a Round Head bolt.

In any case, the process is essentially identical.