https://forums.autodesk.com/t5/fusion-design-validate-document/is-it-possible-to-change-parameters-for-a-linked-imported/m-p/7519003#M184167 <P>In Sketchup, there are dynamic components that have parameters to set various characteristics of the component (height, width, angle, etc.) when used in another design (downloaded from their 3d-warehouse). Can something like this be done in Fusion 360?&nbsp;</P> Mon, 06 Nov 2017 04:24:30 GMT ittay.dror 2017-11-06T04:24:30Z https://forums.autodesk.com/t5/fusion-design-validate-document/is-it-possible-to-change-parameters-for-a-linked-imported/m-p/7519003#M184167 <P>In Sketchup, there are dynamic components that have parameters to set various characteristics of the component (height, width, angle, etc.) when used in another design (downloaded from their 3d-warehouse). Can something like this be done in Fusion 360?&nbsp;</P> Mon, 06 Nov 2017 04:24:30 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/is-it-possible-to-change-parameters-for-a-linked-imported/m-p/7519003#M184167 ittay.dror 2017-11-06T04:24:30Z https://forums.autodesk.com/t5/fusion-design-validate-document/is-it-possible-to-change-parameters-for-a-linked-imported/m-p/7519174#M184168 <P>The short answer: No</P><P>The long answer: Kind of, because you can either update the source file of the linked component (but than you are changing all targets or you can breake the link&nbsp;but than updates in the source (original) of the link will not be populated into the destinations anymore.</P> Mon, 06 Nov 2017 07:05:10 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/is-it-possible-to-change-parameters-for-a-linked-imported/m-p/7519174#M184168 lichtzeichenanlage 2017-11-06T07:05:10Z