topic Re: Bend along Lines in Fusion Design, Validate & Document Forum

Bend along Lines

bplabmac — Fri, 17 Nov 2017 10:04:22 GMT

Hi,

I would like to bend along the lines like on image join

I create a panel, next import dxf and extrude by cutting

parts

any advice

many thanks by advance

Re: Bend along Lines

sanjay_jayabal — Fri, 17 Nov 2017 17:07:08 GMT

Hi @bplabmac,

Here is an idea for how you can do it.

Best regards,

Sanjay Jayabal.

Re: Bend along Lines

etfrench — Fri, 17 Nov 2017 19:45:11 GMT

Here's another way to do it:

Re: Bend along Lines

lichtzeichenanlage — Fri, 17 Nov 2017 19:50:11 GMT

@etfrench: That hits the term bending much more 🙂

Re: Bend along Lines

bplabmac — Sat, 18 Nov 2017 06:39:49 GMT

hi Sanjay,

thk you so much for your answer !

Re: Bend along Lines

bplabmac — Sat, 18 Nov 2017 06:44:32 GMT

Hi @etfrench,

I think that this is a very good way to do, thk you so much

I tried and it's ok, in addition I imported a dxf for the sketch

Re: Bend along Lines

sanjay_jayabal — Mon, 20 Nov 2017 14:52:59 GMT

Hi @bplabmac,

What I suggested was assuming you already had a solid and were looking for a way to create bends. What @etfrench suggested is definitely the better option.

Best regards,

Sanjay Jayabal.