topic Re: Design issue in Fusion Design, Validate & Document Forum

Design issue

Anonymous — Wed, 29 Nov 2017 06:00:41 GMT

Hello All,

I'm a beginner in Fusion 360 and I'm facing some issues while designing water dispenser. I'll be extremely thankful if you can help me out with my design.

I have attached the images for your reference. I'm unable to flatten the tip of the Water dispenser Pencil. Kindly help me out with this.

Awaiting for your reply.

Re: Design issue

lichtzeichenanlage — Wed, 29 Nov 2017 06:34:29 GMT

Create an offset plan from the bottom at that height you want to cut
Use that new plane in "Modify -> Split Body" to cut the tip
Right click the top in the browser and use remove to eliminate that part you don't want to keep

Re: Design issue

jasonhomrighaus — Thu, 30 Nov 2017 00:33:40 GMT

Create your pencil then create a drawing on the end of it, in this case a triangle, then extrude the triangle and set the taper angle to a negative number that fits your design, then use split body and the pencil shaft to trim the edges,

Re: Design issue

Anonymous — Thu, 30 Nov 2017 06:40:03 GMT

Thanks a lot 🙂