https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/7601637#M181222 <P>I have placed text on a square post and then engraved (negative extrude feature) into the post, I then performed a "feature mirror" around a midplane with the intent of having the same text on the opposite surface.&nbsp; It is there but the text is backward, which I suspect that is what a mirror does I need it to read left to right on both posts, in other words mirror and rotate.&nbsp; I think I have done this with text in autocad but, can't seem to get it to work in Fusion.&nbsp; Any suggestions would be welcome as I have a lot of posts to do each with different text, sure would cut down on the keystrokes if this could work.&nbsp;</P> Wed, 06 Dec 2017 16:13:06 GMT s.david.baxter 2017-12-06T16:13:06Z https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/7601637#M181222 <P>I have placed text on a square post and then engraved (negative extrude feature) into the post, I then performed a "feature mirror" around a midplane with the intent of having the same text on the opposite surface.&nbsp; It is there but the text is backward, which I suspect that is what a mirror does I need it to read left to right on both posts, in other words mirror and rotate.&nbsp; I think I have done this with text in autocad but, can't seem to get it to work in Fusion.&nbsp; Any suggestions would be welcome as I have a lot of posts to do each with different text, sure would cut down on the keystrokes if this could work.&nbsp;</P> Wed, 06 Dec 2017 16:13:06 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/7601637#M181222 s.david.baxter 2017-12-06T16:13:06Z https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/7601866#M181223 <P>Try using the circular pattern tool instead of mirror. The axis or rotation would be the center of the post (you may need to build a work axis or dummy feature to get this)</P> Wed, 06 Dec 2017 17:03:15 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/7601866#M181223 I_Forge_KC 2017-12-06T17:03:15Z https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/12057452#M181224 <P>This solve the problem for me, thank you.</P> Sat, 24 Jun 2023 04:04:47 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/12057452#M181224 henry.f.camacho 2023-06-24T04:04:47Z https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/14114707#M331219 <P>I just set the text on the opposite side of a surface. I suppose a constructed reference plane would work as well.&nbsp;</P> Sun, 03 May 2026 04:56:51 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/mirror-text/m-p/14114707#M331219 rdoeksen 2026-05-03T04:56:51Z