topic Re: Limiting a Pattern in Fusion Design, Validate & Document Forum

Limiting a Pattern

Anonymous — Tue, 12 Dec 2017 20:54:30 GMT

I'm new to Fusion 360 ( and CAD as a whole) and could use a little advice on a current project of mine. The first pattern you see here I would like to cut off (or stop) once certain shapes hit the inner most constructed circle, but I'm not sure how to do it. I suppressed some off the pattern when I created it, but as you can see some parts are half in half out. Aesthetically I'm ok with this occurring with some of the shapes, but I will be adding more circular patterns radiating off this center one so I need to clean this up to move on. Thoughts?

Re: Limiting a Pattern

Phil.E — Wed, 13 Dec 2017 18:16:04 GMT

Hi, welcome to the Fusion 360 community.

Have you tried using Trim to trim the lines outside the circle? That should do the trick.

Please let me know if you have more questions.

Thanks,

Re: Limiting a Pattern

Anonymous — Wed, 13 Dec 2017 21:56:12 GMT

Thanks so much Phil that totally did the trick.